| Product / Product Description | Hardner Mixing Ratio | Packing | Thinner Recommended | Thinner Intake | Area of Application |
Drying Time |
|||
| Spray | Brush | Roller | Touch | Hard | |||||
| On Metals | - | - | - | - | - | - | - | - | - |
| MRF MetalCoat Etch Primer Yellow | 1:1 | Two | Thinner for finish | 25-30% | 10-15% | - | On metals | 5-10 min | 2hrs |
| Metal Coat Primer Surface Grey (Or) | 10:1 | Two | Thinner for finish | 20-25% | 10-15% | - | Metal/ Wood/ FRP Plastics | 15-20min | 8hrs |
| Epoxy Zinc Phosphate Primer Grey | 4:1 | Two | Thinner 1110EP | 20-25% | 10-15% | - | Only on Metals | 1hr | 16hrs |
| Epoxy Red Oxide Primer | 5:1 | Two | Thinner 1110EP | 20-25% | 10-15% | - | Only on Metals | 1hr | 16hrs |
| Epoxy Putty Grey/White | 2:1 | Two | Thinner 1110 EP | 25-30% | - | - | Metal/ Wood/ Plastics | 30min | 8hrs |
| Metal Coat Glossy Metallic /clear | 4:1 | Two | Thinner for finish | 20-25% | 10-15% | - | Metal /Wood/ Plastics | 30min | 8hrs or overnight |
| Metal Coat Matt Finish/Clear | 6:1 | Two | Thinner for finish | 20-25% | 10-15% | - | Metal/ Wood/ Plastics | 30min | 8hrs or overnight |
- Very mild coat to be given after 20 minutes induction period of mixing base and the hardner.
- Over coating to be done after 1hr and before 2hrs.
- Apply one coat of either Metal Coat Ps Grey or Epoxy Zinc Phos Primer
Grey, by spray or brush
after selecting suitable primer. - Allow it to dry 8hrs and sand the surface with 320 water emery paper.
- Apply Epoxy Putty by putty blade if required.
- Allow it to dry overnight and sand the surface to remove excess putty and to smoothen the surface.
- Apply second coat of Primer Surfacer of Epoxy Zinc Phos Primer.
- Allow it to dry overnight and scuff the surface with 320 emery paper (wet cutting for metals only).
- Apply two coats of Metal Coat Finish paint by spray after mixing with suitable thinner.
- Between two coats allow 8hrs or overnight dry and scuff the first coat by 400 emery paper (wet cutting).
- In case of metallic finish paints, no scuffing should be done and wet
on wet clear coat to be applied
after 15-20 min of finish paint. - Application of clear is a must for metallic finish paints irrespective of the surface.
- In case of brass items, existing surface (if it is old) has to be
buffed by a buffing machine or the
surface must be cleaned with brasso thoroughly. - Subsequently, clean the surface with MRF thinner for finish.
- Do not handle the object by hand and leave the finger impression,
use jiggs or hooks to hold the
object and apply one to two coats of MRF Metal Coat Glossy Clear only by spray application.